• Welcome to realmuscleforum.com
  • TEST E FIRST TIMER/problem

    Discussion in 'Anabolic Zone' started by crormaSoila18, Oct 9, 2012.

    1. crormaSoila18

      crormaSoila18 Well-Known Member

      Joined:
      Jan 2011
      Posts:
      38,235
      Likes Received:
      0
      OK so first cycle ever and i spent a good 4 months reading about the stuff before doing anything. I just took my 3rd pinn tuesday in the quad. it is Test E from Kalpa pharmaceuticals 250mg/1ml. they are 10 ml vials and i use 1 ml every 3rd day. so the problem is it is swollen and i have SLIGHT feverish syptoms and jus feel beat down a bit. ive looked up abscess and pitting edema and neither fit the description of my leg but it is noticably bigger than the left the area is warm and slight redish(but very little). pain feels like i tore my musle tissue. i use new pinn and alchole swabs to keep clean also washing hands before. is this normal ive read both yea its fine and others say go to the doc. its only been about 24 hours since i pinned

       
    2. Raleoxilevz

      Raleoxilevz Well-Known Member

      Joined:
      Dec 2010
      Posts:
      43,682
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      Its hard to say, When I had the same thing happened it hurt like a pulled muscle was warm red and swollen and took a week for the abcess to apear then next thing you know I have a crater in my leg. I would give it a few days and if it doesnt get better go to the hospital or doctor. The last thing you wanna do is get a really bad infection. Just be cautious and if it doesnt go away in a day or two go get checked out
       
    3. Canellesao

      Canellesao Well-Known Member

      Joined:
      Jan 2011
      Posts:
      36,073
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      Sounds like cellulitis. That's dangerous. And requires IV antibiotics.

      Get a pen. Circle the red area. If the red is outside the pen by morning go to the er. For real.

      Tell them you bumped it on a sharp edge. It's a legit reason.

      In the mean time. Just to see if its could be "test flu" and just a sterile abscess combined. Hot compresses. As hot as you can take. Should disperse and oil left under the dermis.

      But if its painful, swollen and you're losing mobility it's a worst case scenario.

      Just popping antibiotics you have on the shelf won't do.

      This is from experience. Not a guess.
       
    4. defelqy

      defelqy Well-Known Member

      Joined:
      Jan 2011
      Posts:
      38,829
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      k well i should give more detail on redniss its no more red than if some other tissue was inflammed from injury... there is not redness near the place i pinned jus all over the musle is swolen and honestly not much different in color then the rest of body.... should i switch between ice and heat.......but like i said compairing visuals to other images its NOTHING like i seen... i considered that i might have warmed the oil a lil to much before pinning
       
    5. parnassto

      parnassto Well-Known Member

      Joined:
      Dec 2010
      Posts:
      34,818
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      was this your first quad shot? Sometimes different muscle react different even if it is from same vial.
       
    6. defelqy

      defelqy Well-Known Member

      Joined:
      Jan 2011
      Posts:
      38,829
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      The hot compress is to disperse the oil. Icing it will not help. Hot compresses. Hot as you can take. That should clear it up. And if the area is red like the rest of you that it's normal no? Just swollen.

      Could be the oil was hot enough to follow the pin on the way out causing the abscess. And not all abscess are bad. Just annoying. It's the oil between the dermis and the muscle tissue.

      I never in 10 years heated my gear before injecting. Never seen a need to. Thinning it out to much may have caused this.

      What side needle are you using?
       
    7. Canellesao

      Canellesao Well-Known Member

      Joined:
      Jan 2011
      Posts:
      36,073
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      3ml x 5/8 25g
       
    8. remstation

      remstation Well-Known Member

      Joined:
      Jan 2011
      Posts:
      39,969
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      That is not long enough for a quad in my opinion, I always do 1.5" for quads 1" minimum. Mosty likely the oil is trapped and you need to use heat and get it moving.
       
    9. landmenn

      landmenn Well-Known Member

      Joined:
      Jul 2011
      Posts:
      943
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      ok ill keep you posted for the next couple of days
       
    10. jailynn24hb

      jailynn24hb Well-Known Member

      Joined:
      Jan 2011
      Posts:
      82,194
      Likes Received:
      0
      TEST E FIRST TIMER/problem

      I'd use that in a delt only. Get some 1.5" pins.

      I'd blame your pin on this. Heat will fix it.
       

    Share This Page

    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies.
      Dismiss Notice